wiki/networking/Aruba S2500.md

Reset the Switch to Factory Defaults

The switch can be reset through the on screen display's menu. This can be controlled using the two available buttons, menu and enter.

To factory reset the switch, do the following:

1. Press the menu button to bring up the on screen menu. You may have to press the button twice, once to activate the screen and once to open the menu.
2. Press the menu button until you see that Maintenance is selected.
3. Press the enter button.
4. Press the menu button until Factory Default is selected.
5. Press the enter button once to select, and a second time to confirm.

Reset the Admin Password

Guide here.

Update the Switch's Firmware

To update the switch's firmware, you will need to copy the upgrade file to a USB drive and connect it to the USB port on the rear of the switch.

Guide available here.

Connecting to the Switch

Console

The Aruba S2500 has a micro USB port on the back which exposes a serial interface that can be used to manage the switch.

To connec to the serial interface you will need a computer, a micro USB cable, and a serial application (here we are using screen).

1. Connect the USB serial port on the back of the switch to your computer
2. Connect to the serial port with screen
   • sudo screen /dev/ttyUSB0 9600 (replace ttyUSB0 with the device node your system assigns to the switch)
3. Login with the default username and password
   • username: password
   • password: forgetme!

You should now be dropped to a shell that looks like the below

(ArubaS2500-48P-US) >

Ethernet (broken)

The Aruba S2500 provides a Web UI that can be used to configure the switch.

The WebUI forces HTTPS by default and the ciphers supported are not permitted by most modern browsers. You can enabled outdated ciphers in your browser which will enable you to sucessfully connect, but the WebUI may still fail to display.

To connect to the WebUI

1. TODO: enable the Quick Setup WebUI via the front panel menu
2. Connect an ethernet cable between your device and one of the 1GbE port on the front of the switch
3. On your machine, assign the interface a static IP with the follow configuration
   • IP: 172.16.0.2
   • Subnet Mask: 255.255.255.0 or /24
   • Gateway: 172.16.0.1
4. Connect to http://172.16.0.254 in your browser.

You should now have access to the WebUI.

Running through Quick Setup

Console

After logging into the switch's console, you need to launch the switch's Quick-setup program.

This can be done by running the enable command and providing the password enable as seen below. You will then need to press y berfore the Quick-setup prompt times out.

ArubaS2500-48P-US) >enable
Password:enable
Quick-setup helps in setting the basic configuration of the system

Autoconfiguration of system will be stopped, if Quick-setup is launched by user

Invoke Quick-setup (y|n)??? [y]:y